Zz9000 and AmigaOS 3.2.2 isn't working

MNT ZZ9000
1

Hi Everyone,

My zz9000 doesn’t work with AmigaOS 3.2.2 roms/OS
I am using an A4000D with a rev6 68060 (full version.)

I am using v1.12.1 firmware and drivers.
There are no other Zorro cards, used in this system.
When I boot the card isn’t recognized by the drivers at all.
It does not show up in SysInfo, nor does it show up when booting into Early Startup Control.

Suggestions?

Thanks!
bob…

1 Like
2

I believe the hardware works, as I am seeing normal amiga graphics modes via the HDMI port.

bob

3

And one last test, I inserted my BigRam+.
It isn’t recognized until I remove the zz9000. (before removing the zz9000, I tried BigRam is in any other slot - no joy.) I did use the NoFast version of the firmware, as well.

bob.

4

I use a configuration practically identical to yours, only with the 060 rev. 5, and I don’t seem to have any kind of problem.

  • Amiga model: 4000TX
  • 680x0 CPU: 68060 Rev. 5 A3660 rel 1.1
  • RAM Configuration: 112+256
  • Kickstart, AmigaOS Versions: 3.2.2-3.2.2
  • ZZ9000 Firmware version:1.12.1
  • ZZ9000 Driver version:1.12
5

Thanks for the message! I decided to try another slot, which ended up working. It appears that there is a fault with the lowest slot on my daughter card, for the A4000. “Old Computer Syndrome”.

Thanks again. Case Closed.

bob

1 Like
6

JEsus! the lowest slot in an old computer syndrome??
Dammit, my UK A4000D with 030 and OS3.2.something won’t recognize card either. And I hate moving this card!!!